Ignition coils manufacturer and supplier with Hj-auto
Auto ignition coil factory with Hj-auto: Diagnosing a Bad Ignition Coil: Ignition coils typically have a long life of operation — over 100,000 miles. However, they can malfunction eventually, causing that dreaded misfire. This issue will probably start out slowly while being hardly noticeable but will become more problematic over time. When a misfire occurs, even for a few seconds, your engine computer management will likely detect the issue and generate a trouble code. At which point the check engine light comes on. With a diagnostic scanner at a garage or auto parts store, you can then see which cylinder is misfiring and proceed from there. Another sign of a misfire can be a rough engine idle. In extreme cases, the vehicle may feel like it’s surging at a high RPM or like it may stall at low speeds. Other signs that you have a bad ignition coil are worsening gas mileage, sluggish acceleration and a backfiring engine, meaning you hear a loud bang as unburned fuel escapes from the exhaust system. Read extra information on car ignition coil.
The ignition coil is an important part of a car, Haiyan ignition coil manufacturer will give you a professional introduction to the ignition coil n this blog. The car ignition coil is a crucial component of the internal combustion engine. It is an electronic device that converts the 12 volt battery voltage to around 20,000 volts. The automotive ignition coil has a high-voltage winding and a low-voltage winding. The high voltage winding is connected to the battery terminal, while the low voltage winding is connected to the spark plug wire. When you crank your engine, current flows through the primary windings of your car ignition coil and generates enough power to jump across to secondary windings in order to create a spark at your spark plug wire.
Principle of the ignition coil: It is composed of the main coil, a secondary coil, a magnetic core, a switching transistor and other auxiliary components. The main coil is charged by a battery, and the secondary coil is discharged by a spark plug to ignite, and the triode is responsible for switching. The charging time is controlled by the battery voltage and the engine speed to ensure that the energy is consistent each time. The ignition coil has two types: 3-wire and 4-wire. The 3-wire is the power supply positive, negative, switch control (ECU command), and the 4-wire has one more ignition detection. Wire can detect whether the spark plug is ignited (whether there is discharge current in the secondary coil). Ignition coil manufacturer has more than 30 years of production experience.
Using a collapsing magnetic field to induce an electric current: When a magnetic field has been created by applying an electric current to a coil of wire, any change in the electric current (increase or decrease in current flow) creates the same change in the magnetic field. If the electric current is switched off, the magnetic field will collapse. The collapsing magnetic field will then induce an electric current into the coil. If an electric current used to create a magnetic field is switched off, the magnetic field collapses, which induces another electric current into the coil.
The Kettering ignition system became virtually the only type of ignition system for mass-produced petrol cars, and stayed that way until electronically switched and controlled ignition systems started to replace mechanical ignition systems during the 1970s and 1980s. The basic principle of an ignition coil: To produce the required high voltages, ignition coils make use of the relationships that exist between electricity and magnetism. When an electric current flows through an electrical conductor such as a coil of wire, it creates a magnetic field around the coil (Figure 2). The magnetic field (or, more precisely, magnetic flux) is effectively a store of energy, which can then be converted back into electricity.
The hardware accessories series is available in a wide range of types and specifications. Haiyan hardware accessories manufacturer carries out strict quality monitoring and cost control on each production link of hardware accessories, from raw material purchase, production and processing and finished product delivery to packaging and transportation. This effectively ensures the production of hardware accessories manufacturer has better quality and more favourable prices than other products in the industry. See even more info at hj-auto.com.
Haiyan aijian Co.Ltd. is a car ignition coil manufacturer, which are seated on No.338 Yanjia Road, Wanghai Haiyan Jiaxing, Zhejiang, locating western Hangzhou bay cross-sea bridge,3.5 KM far from the Zhajiasu high way exit,1.0 km distance from Huangpu high way exit, convenient transportation, is the centre of economic of shanghai-Ningbo-Hangzhou triangle. The main products of Haiyan wholesale automotive ignition coil manufacturers contain car ignition coil pack, plug coil, spark coil, tool cabinet, hardware accessories, and precision matching pieces of Japanese host, every year manufacturing ignition coils 1,000,000 PCS, cars pare parts 2,000,000 sets,3,000,000 sets of Japanese hosts accessories. Widely export to South and North America, Europe, South Africa, and Asia.